We test before we treat
Reading the water first isn't optional to us.

Kilo 18 is a point further out along the Old Makkah Road at the southeastern edge of Jeddah governorate near the Bahrah boundary, within the logistics and storage belt that has grown along this route. Pools here are rare, water carries heavy industrial sediment, and the work requires understanding of an area far from the main city.
Pools in Kilo 18 are very rare, and first-fill water carries heavy industrial dust and may hold fine metal particles. For the method itself, see the full swimming pool cleaning page.
The logistics zone around Kilo 18 releases heavy industrial dust and metal particles. First-fill water carries these deposits and the filter needs deep pre-filtration from the start. We test the water and decide whether simple filtration is enough or specialist treatment is needed.
Kilo 18 lies far from the main city and its services. Pools here may sit in small guesthouses or worker housing, and regular maintenance is rare. Work needs special planning and access may be complex.
The location is far from the coast and dense building, yet heat is extreme and dust settles more lightly. Water may turn quickly from heat and infrequent use, and chemical balance shifts rapidly.
A point on the Old Makkah Road close to the Bahrah boundary in the extreme southeastern corner of Jeddah, within a developed logistics and storage zone, with few scattered houses and sparse documented detail about this exact location.
We test the water first in Kilo 18 because local water quality and metal load differ from other areas and guide all decisions.
Walls may carry a fine layer of metal dust and particles, so we scrape carefully and rinse thoroughly.
The floor accumulates heavy metal and mineral deposits, so we vacuum gently and wait for dust to settle before final testing.
The skimmer and baskets may fill with industrial dust, so we inspect and clean them thoroughly of sediment.
The filter may need specialist pre-filtration because metal load is heavy, and multiple backwash cycles are essential.
We test chemical balance after each step and treat the water to prevent metals settling and accumulating fast.
pH, sanitiser and hardness are read at the start.
Floating leaves and debris come off before we brush.
Algae and the oily waterline film cling to the surfaces.
Silt settles in the deep end and the corners the return jets never reach.
The skimmer and pump baskets are cleared and the filter checked or backwashed.
With the water clean, we balance and dose, then walk the pool with you before leaving.
Reading the water first isn't optional to us.
The company runs a large crew, and we send a team rather than one person.
Pumps, vacuum heads and the test kit come with the team.
If the pump or the plumbing is the real problem, we tell you.
Photographs from real jobs carried out by the crew.












The commitment is simple enough to actually keep: we don't leave until you've seen the result and had your say on it.
Industrial area: workshops, warehouses and loading yards
A remote industrial zone means pools are very rare and work requires careful planning for access and equipment. The team arrives with a complete solution because other services are distant, and the pool may be a valued asset in an isolated location.
We provide these in Kilo 18 too, and more than one can share a single visit.