Clean first, then disinfect
The common mistake is spraying disinfectant over dirt.

Al Buhairat is a new development district surrounded by vacant plots and ongoing construction work. Fine dust from building sites and newly paved streets settles on every surface and into grout lines within hours. Disinfection here begins with actual cleaning to remove the dust and construction debris, then allows proper contact time for the disinfectant to work on the exposed surface.
New homes here accumulate construction dust on surfaces faster than older districts, and drains carry fine building materials from the surrounding work rather than normal household debris. For the method itself, see our disinfection and sanitisation service in detail.
Fine dust from active building sites settles on surfaces and into grout lines continuously. Disinfectant applied over dust cannot reach the surface underneath. Initial cleaning removes this dust layer entirely, so the disinfectant reaches what actually needs treating and has time to work.
Recently constructed homes have trapped moisture in foundations and floor slabs. This moisture weakens the disinfectant's ability to act. Selecting a product suited to damp surfaces is part of the plan made on site before any work starts.
Grout lines and drains in new homes contain sand and construction particles from neighbouring work. These need separate cleaning before disinfecting, otherwise the product cannot penetrate into the gaps and joints where it should work.
The district sits within the Obhur Al Shamaliyah subdivision scheme where Jeddah Municipality has recently completed asphalting and lighting work on dozens of internal streets. New building and excavation activity continues around the residential properties.
Dust from new streets and building sites settles on surfaces very quickly, so initial cleaning extracts this dust completely from every surface, corner and grout line before anything else.
High-touch surfaces in a new home carry construction dust from the surrounding work, requiring thorough pre-cleaning before the disinfectant can work effectively on them.
Newly installed bathrooms may retain materials from installation, making cleaning of taps, handles and grout the essential first step before disinfection can be trusted.
Kitchen surfaces and food prep areas accumulate construction dust rapidly, so cleaning it away first ensures the disinfectant works properly on the actual surface you need protected.
Drains and grout lines in a newly built home contain sand and building debris, requiring brush cleaning to remove this material before any disinfectant can penetrate effectively into the joints.
The disinfectant requires full contact time before wiping, followed by ventilation that clears excess moisture and odour faster in the newer, tighter construction typical of this district.
A move-in, an illness and an after-party aren't the same job.
Grime and grease shield what's under them.
A disinfectant has to stay wet on the surface to work.
Handles, switches, taps and rails are done by hand because they carry the most and need direct contact that fogging alone doesn't give.
Once the hard surfaces are done, a fine fog reaches the air, the fabrics and the corners a cloth can't, settling over what hand-wiping misses.
We open up and air the rooms, then walk the home with you before leaving.
New development: ongoing construction and vacant plots between the homes
A new home in this developing district carries construction dust and the residue of ongoing building activity all around it. Disinfection starts with thorough cleaning to remove dust and moisture, because no product works on an unclean surface.
The common mistake is spraying disinfectant over dirt.
The company runs a large crew, and we send a team rather than one person.
The foggers and the products come with the team.
If what you need is deep cleaning or mould work rather than disinfection, we tell you.
Photographs from real jobs carried out by the crew.












The commitment is simple enough to actually keep: we don't leave until you've seen the result and had your say on it.
The district lies between Jeddah Madinah Road to the east and King Abdulaziz Road to the west, with Abhor Park marking the centre. We access homes via Prince Abdulmajeed Road and the internal streets lit and paved recently throughout the development.
We provide these in Al Buhairat too, and more than one can share a single visit.