We test before we treat
Reading the water first isn't optional to us.

Al Yaqut is a mixed district where building work and commercial traffic never stop, and pools here collect the dust of construction and daily movement at once. An initial chemical test reveals the real load on the water before any cloudiness or settling shows to the eye.
Pools here take in dust from active building sites nearby, and the filter clogs weeks faster than it would in settled older quarters where construction finished long ago. For the method itself, see our guide to swimming pool cleaning.
Active building sites around Al Yaqut release fine particles that the wind carries directly into pools. This dust differs from road dust because it is coarser and heavier, and it not only settles on the floor but clings to the walls and steps where it hardens if left untreated.
The Al Yaqut Walkway and the busy streets around it mean constant vehicle movement and dust clouds. This carries fine oily particles from tyre wear and engine soot. Pools here never rest, even at night, because the air overhead is always moving and dusty.
Some parts of the district have older pipework that carries iron particles and fine sand in incoming water. This means the filter must be backwashed far more often than in zones where pipes were laid recently and with modern materials.
An inland district between Al Lulu and Al Sawari, cut through by Aabir Al Qarat Street and Prince Abdulmajeed Road. Heavy traffic on both main roads carries with it the finest street dust and construction debris on the air.
In Al Yaqut, water carries suspended construction dust that may hide deeper chemical issues, so initial testing is essential before any chemical additions are made.
Pool walls here collect fine dust from the surrounding roads, and brushing must be deep to remove the thin sediment layers that build up fast in mixed commercial and residential areas.
Construction dust clogs the filter rapidly, so vacuuming the floor first is necessary before backwashing to reduce pressure on the filter medium and extend its life.
The skimmer fills quickly here with road and construction dust, and frequent inspection is needed so the basket does not overflow and spill debris back into the pool.
Filter backwashing must run longer here because fine particles from building work do not rinse away easily like heavier desert sand would in other districts.
Chemical balance needs testing every week, and higher chlorine doses may be needed because the organic load is raised by the dust and particles from busy roads and active sites.
pH, sanitiser and hardness are read at the start.
Floating leaves and debris come off before we brush.
Algae and the oily waterline film cling to the surfaces.
Silt settles in the deep end and the corners the return jets never reach.
The skimmer and pump baskets are cleared and the filter checked or backwashed.
With the water clean, we balance and dose, then walk the pool with you before leaving.
Mixed district: shops at street level with homes above them
Mixed district means pools here shake from the shops and movement beneath them, cooking oils from flats above drift into the air, and dust from roads and building work enters far more easily than in purely residential quiet areas.
Reading the water first isn't optional to us.
The company runs a large crew, and we send a team rather than one person.
Pumps, vacuum heads and the test kit come with the team.
If the pump or the plumbing is the real problem, we tell you.
Photographs from real jobs carried out by the crew.












The commitment is simple enough to actually keep: we don't leave until you've seen the result and had your say on it.
Access to pools here depends on knowing the Al Yaqut Walkway and Aabir Al Qarat Street because these two landmarks define where pools cluster in the district, and the team needs precise addresses because the heavy traffic makes navigation by description alone unreliable.
We provide these in Al Yaqut too, and more than one can share a single visit.